Prepare your natural lashes by cleaning them thoroughly to increase durability.
1. Use a tilt bucks, gently curl your natural lashes, and then gently apply a thin and even layer of bond beneath them - a little extend long. Make sure to brush the lashes in a single direction so that they do not stick together.
2. For thinner lashes, it is recommended to apply two layers of bond, while for thicker lashes a layer is sufficient. Allow Bond to dry and become slightly sticky by waiting for approx. 20 to 30 seconds.
3. Apply the Lash Clusters under the bottom of your natural lashes and make sure they are located slightly away from the waterline to prevent potential irritation - about 1-2mm.
4. When you are satisfied with the application, press the lashes together to mix both the lash band and the individual clusters - creating a natural look.
5. To remove any leftovers or excess glue, gently apply a thin layer of seal above and below your lashes, focusing on the areas where you feel it is necessary.
TIP: We recommend waiting 24 hours before bathing after lash clusters. When taking a bath, avoid getting water directly on the lashes